How to program a urc remote to a philips tv

In the auto search method, all the universal remote codes are gone through scanning process in the remote. It scans one code at a time to find out the correct remote code that works with your remote to program the control. Follow the instructions given below:. By using the keycode we can easily program a universal remote and the keycode identifies the make and model of your equipment. Chunghop Universal Remote Control. Disclaimer: DirecTutor.

Republication of the contents are expressly prohibited without the written consent of DirecTutor. Comments to : DirecTutor. Main menu. Enter one of the 4 digit code from the code table below With the device turned on, press several buttons to test if the Device responds. Repeat steps 1 to 4 for other devices you wish to set up the Remote control for.

Notes After a valid code entry, the red light indicator turns off. It may blink, but it may not. Just hold it down for 5 seconds and continue with the programming. Method 2. Underline or mark the code in the manual to ensure that you can find it quickly in the future. On newer remotes and newer TVs, the list of available codes may pop up on your screen after you prompt it for programming with the device button.

Older devices usually use 4-digit codes. Newer devices usually use 5-digit codes. The device codes for universal remotes are listed online. You will find the codes for your remote online. Enter the code on the number pad to make your device recognize your remote. Use the number pad on your remote to enter the corresponding 4 or 5-digit code for your device. Based on the model of your remote, the blue or red lights on your remote should turn off if you enter a valid code.

If the blue or red light on your remote blinks once and then stays lit, your code is invalid but you can enter a new one. Method 3. The 4-digit SR remotes are unique models and need to reset before they can be used. Press and hold the standby button.

Release the button as soon as your device and remote shut off. This should reset you remote and your device to synchronize them with one another. Try using the commonly-used buttons on your remote to test the device. To check to see if the programming was successful, try entering some common commands for your device using the remote. Try changing channels, volume, or input to see if the essential buttons work. If the device is responsive to your commands, it is successfully synchronized with your remote.

Move any plants or obstructions out of the way to ensure that the signal for your remote will clearly reach your device.

Repeat this process on other devices if you want to. If the other device is near the one that you just programmed, unplug the one that you already programmed to prevent any mistakes.

It should be in the back of your remote's instruction manual. The code is different depending on your remote's model. You can find a list of Insignia codes online if you don't have access to the manual. Yes No. Not Helpful 7 Helpful 5. What do I do if the up and down buttons don't work on my Philips universal remote? Try re-programming your remote and your device.

There may have been a software update that is interfering with some of your buttons. If the up and down buttons on your standard remote are working, this is likely the case.

Run through the programming process again to reset it. Not Helpful 0 Helpful 0. Program your remote to synchronize it with the television, not the Chromecast. It should work the same as a standard remote. Keep in mind, the only buttons that work with Chromecast on any remote are the play and pause buttons. You still have to control what plays through your phone or computer.